1. The slit

After the blade thickness of the same size is cut, on the one hand, the cement slag, sand, dust and other dirt in the seam is clear, on the other hand, the error of adjusting the width and width of the original seam is adjusted, so that the interval reaches the same width, so as to avoid the disadvantage that some joints are too narrow and not filled with glue.

2. The seams

After the completion of the opening process, then do no joint stitching treatment, so that the stone to achieve the effect of integration; And do waterproof treatment, as far as possible to reduce water on the ground and the formation of water stains.

3. The coarse grinding

According to the size of the ground drop, it is divided into deep, medium and shallow grinding to eliminate scratches on the stone surface and level off the cutting mouth.

4. Fine buffing

The use of special stone maintenance equipment, fine grinding to eliminate the traces left by rough grinding, after fine grinding and finishing, the stone surface to restore the original luster. (In the process of refurbishing and grinding, the high-power suction and water absorption AX machine is used to absorb water in time to reduce the penetration of water to the ground and avoid water stains on the SLATE as far as possible)

5. Crystal

The stone crystal surface special machine and polishing pad are used to evenly penetrate the stone curing crystal powder (liquid) into the molecular gap of the stone and solidify into a transparent protective layer with high strength and toughness.

conclusion

After crystal face treatment, the stone surface contains hard titanium particles, which makes the surface harder. At the same time, it also plays the role of anti-skid, anti-fouling, high temperature resistance, acid and alkali resistance.